Cone Crusher 36” Series

The product analysis depends on many factors, among which are the C.S.S., the crushing chamber design, and the type of material being crushed. Over the years, we have accumulated a lot of data about product curves, and for most applications, the curves given at
the bottom of the page provide good approximations of the product that can be expected. In general, the product curve is directly related to the C.S.S., and the percentage of the product that will be smaller than the C.S.S. is typically as shown in the table below.
Product size distribution diagrams for clean, friable granite: Find the C.S.S. on the vertical axis and follow the horizontal line across to the colored vertical line. The curve passing through the meeting point of these two lines gives the size distribution of the crushed product.

Fine Feed Arrangements :

For all crushing chamber designs, material smaller than the C.S.S. should be screened out from the feed, and we recommend a vibrating feeder ahead of the crusher. To ensure high capacity, high reduction, and low wear, it is essential that the crusher is evenly fed and that the feed is evenly distributed all around the feed opening. Special attention should, therefore, be paid to the design of the feeding system.